Pressure Washers
3000 PSI - 5.5 GPM Pressure Washer with Comet RW5535 or General Pump PSS5535
Pressure Ranger 2-in-1 Cleaning System
3200 PSI – 5.2 GPM Pressure Washer with Centurion Pump CTB4S
- Featured
- Most relevant
- Best selling
- Alphabetically, A-Z
- Alphabetically, Z-A
- Price, low to high
- Price, high to low
- Date, old to new
- Date, new to old
Recently Viewed Products
How to Choose the Right Pressure Washer
A pressure washer purchase hinges on a few numbers and one workflow question: how much water you can move (GPM), how hard you can hit a surface (PSI), how the pump is driven, and whether the same rig also needs to handle soft washing. Nail those and a good machine will run five to ten years of daily use. Miss them and you'll either burn out a pump or under-spec a job.
GPM matters more than PSI
Every new buyer fixates on PSI. The pros know GPM is what actually cleans. Pressure breaks the bond between dirt and surface; gallons-per-minute rinses it away. A 4,200 PSI / 3 GPM unit will clean slower than a 3,000 PSI / 5.5 GPM unit on the same flatwork. For commercial contractors moving fast on driveways, sidewalks, and parking lots, target 5+ GPM. For light residential work, 4 GPM is enough.
Direct drive vs belt drive
Direct-drive pumps bolt straight to the engine shaft. Fewer parts, lower cost, smaller footprint. They work well for residential and light commercial use but spin at 3,400 RPM, which wears seals faster under heavy duty cycles. Belt-drive pumps spin at around 1,450 RPM, run cooler, last longer, and isolate the pump from engine vibration. If you're running daily for 4+ hours, spend the extra money on belt drive. You'll get it back in pump life.
Engine sizing
Every unit we sell runs on a Honda gas engine because nothing else starts as reliably under field conditions. The GX390 (11.7 HP gross) drives pumps up to about 5.5 GPM; the GX690 (22 HP, V-twin) is what you need for 8 GPM and up. Undersized engines bog under load and fail early. Pull start works for occasional users, but electric start is worth the upgrade if you're firing it up multiple times a day.
Pressure washing only, or two-in-one?
If you do both pressure washing and soft washing, look at the Pressure Ranger 2-in-1 Cleaning System. It runs from 400 to 3,500 PSI on the same machine, so you can flatwork in the morning and soft wash a roof in the afternoon without swapping rigs. For pressure-only contractors, a dedicated belt-drive truck mount will give you better PSI performance and longer pump life.
Pressure Washer Sizing Chart
| Use case | Recommended spec |
|---|---|
| Residential side work, occasional use | 3,000 PSI / 5.5 GPM, direct drive, Honda GX390 |
| Full-time residential contractor | 3,200 PSI / 5.2 GPM, belt drive, Honda GX390 |
| Pressure wash + soft wash combo rig | Pressure Ranger 2-in-1 (400-3,500 PSI, up to 10 GPM) |
| Heavy commercial, daily flatwork, fleet | 4,200 PSI / 8.5 GPM, belt drive, Honda GX690 |
Related Categories
- Surface Cleaners
- Pressure Washer Guns
- Pressure Washer Hose
- Pressure Washer Accessories
- Soft Wash Sprayers
Frequently Asked Questions
What size pressure washer do I need?
For residential side work, 3,000 PSI and 5 GPM is plenty. For full-time commercial contractors running flatwork, fleets, or large lots, step up to 4,000+ PSI and 8 GPM with a belt-drive pump. As a rule of thumb, you'll be limited by GPM long before you're limited by PSI. Buy the most gallons-per-minute your budget allows.
Is GPM or PSI more important?
GPM. Pressure breaks dirt loose, but it's water volume that flushes it off the surface and lets you cover ground fast. Two machines at the same PSI can have very different cleaning speeds depending on GPM. When in doubt, prioritize GPM.
What's the difference between direct drive and belt drive pumps?
Direct drive bolts the pump to the engine and spins it at 3,400 RPM. Simpler, cheaper, and lighter, but harder on seals over time. Belt drive uses pulleys to spin the pump at around 1,450 RPM, running cooler and longer. Direct drive is fine for under 20 hours a week of use; belt drive is what you want for daily commercial work, and typically delivers roughly twice the service life of a direct-drive setup under the same conditions.
Can I use these pressure washers for soft washing too?
Sort of. A standard pressure washer can downstream-inject SH at roughly a 10:1 dilution through a black-tip nozzle, but the resulting mix is too weak for most professional soft wash work and the chemical runs through your high-pressure pump (shortening its life). The right answer for true soft washing is either a dedicated 12V or gas soft wash pump, or the Pressure Ranger 2-in-1, which is built to handle both jobs without compromising either.
Honda GX390 vs Honda GX690: which engine do I need?
The GX390 (11.7 HP gross) handles pumps up to about 5.5 GPM and is the right engine for 3,000-3,500 PSI machines. The GX690 (22 HP V-twin) is what you need to drive 8+ GPM pumps at 4,000+ PSI. Match the engine to the pump's flow rate. An underpowered engine will bog, overheat, and fail prematurely under load.
Do these come ready to mount on a truck or trailer?
Yes. Every unit ships on a powder-coated steel plate with anti-vibration pads, so you can bolt it directly to your trailer deck or truck bed and run. You don't need to fabricate brackets, weld anything, or buy spacer kits. Bolt it down, plumb the hose, fill the tank, and start cleaning.
How long should a commercial pressure washer last?
With routine maintenance, a belt-drive setup will generally outlast a direct-drive setup by roughly 2x under the same use. That means pump oil changes per your pump's spec sheet (typically every 250-500 hours), fresh fuel, and clean water from a buffer tank or filter. The engine almost always outlasts the pump; budget for one pump rebuild or replacement around the midpoint of the machine's life.
